diff --git a/Ploopy-Mini-Trackball-Kit-Assembly.md b/Ploopy-Mini-Trackball-Kit-Assembly.md
index 1f0f5d8..fad740f 100644
--- a/Ploopy-Mini-Trackball-Kit-Assembly.md
+++ b/Ploopy-Mini-Trackball-Kit-Assembly.md
@@ -203,7 +203,7 @@ Take a look at the Scroll Wheel Holder Holder from above. It should be flush wit
 
 ## Step 21: Prepare the Buttons
 
-<INSERT image of buttons, mostly assembled body WITHOUT the PCB scroll wheel holder.>
+INSERT image of buttons, mostly assembled body WITHOUT the PCB scroll wheel holder.
 
 Prepare the following components:
 
@@ -213,7 +213,7 @@ Prepare the following components:
 
 ## Step 22: Attach the Primary Buttons
 
-<INSERT new picture of primary buttons here.>
+INSERT new picture of primary buttons here.
 
 - The right click button has to be bent a little to fit over the scroll wheel axle. Be patient and gentle.
 - Don't forget to insert the screw slowly, to ensure that you don't strip the plastic holding the screw in place.
@@ -221,7 +221,7 @@ Prepare the following components:
 
 ## Step 23: Attach the PCB Scroll Wheel Holder to the Base
 
-<INSERT picture of primary buttons attached + PCB scroll wheel holder here.>
+INSERT picture of primary buttons attached + PCB scroll wheel holder here.
 
 - The PCB Scroll Wheel Holder is the piece of plastic sitting on top of the PCB. It shouldn't require too much force to put on.
 - Once the PCB Scroll Wheel Holder is attached, the Scroll Wheel is fully assembled. Give it a few spins, and give it a few clicks, just to make sure that everything feels right.