Updated Part 2: Drivers (markdown)

Part-2:-Drivers.md

@@ -1,4 +1,5 @@
 
+
 # Drivers
 
 In this section, you will assemble the Drivers of the official Ploopy Headphones Kit.
@@ -222,7 +223,8 @@ You will need the following hardware:
 
 ![enter image description here](https://lh3.googleusercontent.com/pw/AMWts8DZRS-Rg8uQO1vPawOUn8tMgA1ekMaODmLPpjC9V6vvgIK4xqEzyUzelj4Ee_qJkmDlUT6jyQcg1Q9gf6u4fooxS8jUXTC_jFyHdqzl13NxU_hUTT1QfqpnCOUdGibUUPSb_ma33NWVozO5tdeKaK3p=w1434-h955-no?authuser=0)
 - **(!)** Look at the Driver Cap. It should say "NS" on it. Orient the Driver Cap on your work surface such that it matches the photo.
-- The Magnet's red mark determines the side that is South. Note that, in the photo, the red face of the magnet is pointing towards the "S" on the Driver cap.
+- The Magnet's red mark determines the side that is South. Note that, in the photo, the red face of the magnet is pointing towards the "S" on the Driver Cap.
+- The magnet should fit tightly into the Driver Cap. It shouldn't require a huge amount of force to insert, but it should fit quite snug. If it doesn't, try wrapping a single piece of tape around the magnet and insert it again.
 
 ## (!) Step 34: Insert the remaining Magnets into the Driver Cap
 
@@ -234,6 +236,7 @@ You will need the following hardware:
 - Don't let the magnet twist around when you insert it into the slot.
 - *The magnets must be inserted in sequential order.*
 - Repeat the actions in the video for all remaining magnets. [Here is a second video on the magnet insertion process, in case it's still unclear.](https://imgur.com/a/YOAVskD)
+- Again, each magnet should fit tightly into the Driver Cap. It shouldn't require a huge amount of force to insert, but it should fit quite snug. If it doesn't, try wrapping a single piece of tape around the magnet and insert it again.
 
 ## Step 35: Insert the Driver Cap into the Driver Back and screw it in