Updated Part 2: Drivers (markdown)

Part-2:-Drivers.md

@@ -1,3 +1,4 @@
+
 # Drivers
 
 In this section, you will assemble the Drivers of the official Ploopy Headphones Kit.
@@ -104,6 +105,7 @@ You will need the following hardware:
 ![enter image description here](https://lh3.googleusercontent.com/pw/AMWts8D44w6K0HrJQzfq-JXijiHMirxZyP9vDxB8vnB8O4i2MyMqrh9gBH7RiKw9h8XYpm2nUjJNqLWr0XL3MvjyzDizDHny6jx8q3_Fys2DigBdSq-PRv6sPHN7OTwO1Tynvlj3agZBRD_o2HkIKxlMKTFN=w1434-h955-no?authuser=0)
 - This is a good place to double-check if you have the correct Driver Flex Board. It should not need to be bent in order to fit into the Driver Assembly Jig or into the Driver Back.
 - **(!)** Take a good look at how the Driver Flex Board sits on top of the Driver Assembly Jig. Later in this guide, you will be pressing the Driver Flex Board downwards, into the Driver Assembly Jig. *Note that the stem of the Driver Flex Board is not supported by the Driver Assembly Jig*.
+- The Driver Assembly Jig should "grip" the Driver Flex Board if you seat it well, as there are small little pegs that surround the Driver Flex Board. So, give the Driver Flex Board a good push into the Driver Assembly Jig, rather than just resting it on top of the Driver Assembly Jig.
 
 ## Step 14: Remove the backing from the tape on the Driver Flex Board
 
@@ -208,6 +210,7 @@ You will need the following hardware:
 ## Step 31: Screw in all six screws into the Driver Outer Ring
 
 ![enter image description here](https://lh3.googleusercontent.com/pw/AMWts8DFWwjIkQcYCqh5F6glaNDX2Ioh_L7dsPYH5n2Apdcz32A3pUfDY9v23iqPw7cej-SzLXdjDQPj9QcDWJhr2bFmCp48QfKIkJxLMDGMNfV0zu_giGGl7E3Q9yobYcP2jXxPxaeMooCEtK6HuDTX8ePC=w1434-h955-no?authuser=0)
+- When you screw down the Driver Outer Ring, it will stretch the foam, creating tension across it. This is normal.
 
 ## Step 32: Prepare the Driver Cap