Updated 3. Enclosure assembly (markdown)

3.-Enclosure-assembly.md

@@ -36,31 +36,39 @@ If you don't have the hardware, be not afraid. **We sell hardware kits**, and we
 
 ## Step 4: Preparing the scroll wheel holder
 **TODO PIX**
+
+Prepare the following components:
+
 - Electronics assembly
 - Scroll wheel holder
 - Scroll wheel holder holder
 
 ## Step 5: Insert scroll wheel holder holder into electronics assembly
 **TODO PIX**
+
 - **Ensure that the plastic part is oriented correctly**
 - The plastic part requires a bit of force to get into the PCB; be careful not to damage the electronics assembly
 - Press the plastic part on its edges, NOT the middle, as you may break the part if you depress the middle too hard
 
 ## Step 6: Insert scroll wheel holder into scroll wheel holder holder
 **TODO PIX**
+
 Stop laughing at the names already.
 
 ## Step 7: Preparing the base
 **TODO PIX**
+
 - Base
 - 2x heat-set threaded inserts
 
 ## Step 8: Put threaded inserts into base
 **TODO PIX**
+
 Take your time and go slowly. A soldering iron temperature of 350C or 620F is hot enough.
 
 ## Step 9: Assembling the base
 **TODO PIX**
+
 - Electronics assembly
 - Base
 - Primary buttons
@@ -69,18 +77,22 @@ Take your time and go slowly. A soldering iron temperature of 350C or 620F is ho
 
 ## Step 10: Place electronics assembly onto base
 **TODO PIX**
+
 The electronics assembly is seated on the base, but it does not attach. It will eventually be pressed down by the Top, so don't worry about that here.
 
 ## Step 11: Screw secondary buttons into base
 **TODO PIX**
+
 **TODO which screw here?**
 
 ## Step 12: Screw primary buttons into base
 **TODO PIX**
+
 **TODO which screw here?**
 
 ## Step 13: Preparing the top
 **TODO PIX**
+
 - Top
 - 4x heat-set threaded inserts
 - 3x roller bearing dowels
@@ -88,6 +100,7 @@ The electronics assembly is seated on the base, but it does not attach. It will
 
 ## Step 14: Put threaded inserts into top
 **TODO PIX**
+
 Take your time and go slowly. A soldering iron temperature of 350C or 620F is hot enough.
 
 ## Step 15: Put roller bearings onto roller bearing dowels
@@ -98,6 +111,7 @@ Take your time and go slowly. A soldering iron temperature of 350C or 620F is ho
 
 ## Step 17: All done!
 **TODO PIX completed enclosure halves**
+
 Congrats, you finished assembling the enclosure! Pat yourself on the back.
 
 When you're ready, proceed to [[4. Final assembly]] to continue.